Skip to main content
All CollectionsWireless Networking
Can I skip the EnGenius Setup Wizard and access the user interface to configure all the settings manually?
Can I skip the EnGenius Setup Wizard and access the user interface to configure all the settings manually?
Updated over a week ago

"Configuration Steps:
1. For customers using a wired computer to setup the router, please follow the Quick Start Guide for wired connection; customers using a wireless computer to setup the router, please follow the Quick Start Guide for Wireless connection.
2. Follow the steps on the EnGenius Setup Wizard page.

Welcome to EnGenius Setup Wizard – click next

Step1: Setup you Internet Connection – select Manual Setup (Advanced) and click next and on the next page just click next again.

Step 2: Setup the Wireless Security – just click skip

Step 3: Setup your Device Password – type in desired password and click next

Step 4: Setup your Device Time Zone – Just click apply

Model will then reload, just wait for it.

Step 5: Setup your Status and Save Setting – disable DDNS and then click save

System will then reboot, just wait for it.

Then the page will be redirected to
- this is where you can type in the router username and password to access the user interface.

To access the user interface again just simply type in and the page will redirected to then select Router Management and click on START and that will open the Router Login page. Once inside the user interface of the router you can change the settings of the router manually as desired.

Note: If the router is reset back to factory defaults then you need to go through the EnGenius Setup Wizard again. "

Did this answer your question?