All Collections
Wireless Networking
Why can't I change the Transmit Power of my Access Point?
Why can't I change the Transmit Power of my Access Point?
Updated over a week ago

Scenario: I want to limit the ENH202 EIRP to 20dBm only because they may also deploy the ENH202 in regions that do not allow higher 2.4GHz wireless access points broadcasting at beyond 100mW EIRP. I noticed that the ENH202 has the CE marking, which means it must comply with CE standards.

Solution:

By default you could not adjust or change the Transmit power.

To enable the Transmit Power setting, click Operation Mode and uncheck the box beside "Green". Select the Country/Region then click Save/Apply

Applies to: ENS202/EXT, ENS500/EXT, ENH202, ENH500

Did this answer your question?